Antenna Plans

2 Elements Yagi UHF antenna for 410Mhz


This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is 410Mhz with 10Mhz bandwidth. The antenna measurements are computed and then simulated on 4Nec2 antenna modelling software.

Materials

  • 1×1/2″ rectangular aluminum tubing for the boom
  • 1/2″ aluminum tubing for the elements holder cut in half
  • 3/8″ aluminum tubing for the antenna elements
  • 1pc SO239 connector
  • Pop rivets / Rivet tool
  • #10 or #12 AWG copper wire with insulation for the gamma insert
  • 3.5cm 3/8″ aluminum tube for the gamma tube
  • 1 Butteryfly nut and 1bolt 18mm length 3mm diameter
  • 4pcs Stainless steel nuts and bolts 20mm length 3mm diameter
  • Aluminum plate 0.5mm thickness for the tuning stun
  • Collapsible tubes different sizes.
  • U bolt with mounting for the antenna mount

Construction

Measure and cut the boom according to the diagram and assemble the antenna following the antenna construction technique here. Of course you may improvised and follow your own construction technique the goal of the video is to help you visualize the technique I’ve used to build this antenna successfully – but everything is not set in stone.

Note: You may have downloaded a wrong copy of the diagram that sets the spacing to 30.2cm – that is incorrect sorry my mistake I uploaded a wrong version of the diagram when I initially uploaded the article. It has now been corrected with the diagram below.

2 Elements Yagi – dimensions for 410Mhz with 10Mhz bandwidth. You may download the PDF Document here of the measurements. For the gamma match dimensions, you may use the measurements here this will work on this build.

Antenna Pattern from 4Nec2

Free space pattern analysis on 4Nec2
Antenna pattern and gain with respect to ground.
3D diagram gain, antenna current and antenna pattern with respect to ground

Antenna Tuning

Here’s the antenna frequency response and tuning video on my Youtube Channel

Ephraim Gariguez

Recent Posts

Zastone Radios Software

The following are software for radios by Zastone Technology this is publicly and freely available…

2 months ago

PHP 8.2 FPM Tuning

This is a personal note for myself to remember the process I used to tune…

3 months ago

Kicad 6.0 Fix or Workaround for OpenGL required version 1.5

Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…

2 years ago

2 Elements Yagi VHF antenna for 144Mhz

If you liked the 3 elements yagi, this antenna build is very close to the…

2 years ago

WLN Softwares

WLN UHF Radio programming softwares and image for the following models below. The small radio…

2 years ago

TYT Radios Softwares/Firmwares

Software Download Service for TYT Radios This page provides downloads for TYT Radios firmware and…

2 years ago