Building a high performance 3 Elements lightweight end mount Yagi antenna. The awesome Yagi antenna provides many advantages in a number of applications.This antenna has high gain allowing lower strength signals to be received. Yagi antenna has better directivity which enables interference levels to be minimized and have straight forward construction i.e; the Yagi antenna allows all constructional elements to be made from rods simplifying construction. The construction enables the antenna to be mounted easily on vertical and other poles with standard mechanical fixings.
1″ X 0.5″ Rectangular Aluminum tubing for the boom
3/8″ Aluminum tubing for antenna elements
1cm Outside diameter antenna tubing for elements holder
1pc SO239 connector
Pop rivets / Rivet tool
#12 AWG Copper wire with insulation (12″for Gamma match)
Soldering iron
6pcs Stainless steel nuts and bolts 20mm length 3mm diameter
1, Butterfly nut and 1 bolt 18mm length 3mm diameter
Aluminum plate 0.5mm thickness
Collapsible tube (shrinkable tubes)
1 Boom Length 80 cm (Use rectangular aluminum tubing)
Reflector Element (length) = 103.7cm
Driven Element (length) = 98.9cm
Director Element length) = 91.8cm
What can you say about this article and video tutorial, leave your comment on the comment box!
I have an M238 RF mouse that works perfectly fine on Windows and suddenly stop…
The following are software for radios by Zastone Technology this is publicly and freely available…
This is a personal note for myself to remember the process I used to tune…
Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…
If you liked the 3 elements yagi, this antenna build is very close to the…
This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…