Building the gamma match for 3 Elements Yagi UHF 70cm 435Mhz
Just like the gamma match for our 5 Elements Yagi the construction technique for building the gamma match for the 3 Elements UHF Yagi are similar (tolerance level of 3% to 5% on measurements for building the gamma match is fine). The gamma tube for the 5 Elements UHF Yagi is exactly 4.5 cm. Please refer to the diagram for actual measurements. This yagi will give you a good coverage from 430Mhz to 445Mhz on single configuration @ 1:1 SWR on center frequency 435Mhz and about 2:1 SWR on band edges.
I have an M238 RF mouse that works perfectly fine on Windows and suddenly stop…
The following are software for radios by Zastone Technology this is publicly and freely available…
This is a personal note for myself to remember the process I used to tune…
Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…
If you liked the 3 elements yagi, this antenna build is very close to the…
This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…