Softwares

Logitech RF mouse suddenly stop scrolling on Ubuntu 22.04LTS

Note: This procedure is also tested to work with Pop!_OS 22.04 LTS

I have an M238 RF mouse that works perfectly fine on Windows and suddenly stop scrolling on Ubuntu 22.04 LTS. I’ve been looking around for fix but the solutions given are not always straight forward.

If you are experiencing the same issue this might be the quick fix solution to this dilemma.

First is to install Gnome Tweaks. It might be available to install right away on your system so on terminal run.

$ sudo apt update && apt upgrade – followed by

$ sudo apt install gnome-tweaks

Gnome tweaks and the full software can be found here:

https://gitlab.gnome.org/GNOME/gnome-tweaks

The next step after installing Gnome Tweaks is to install Solaar.

Solaar is a Linux manager for many Logitech keyboards, mice and other devices that connect wirelessly to a unifying, Bolt, Lightspeed or Nano receiver as well as many Logitech devices that connect via a USB cable or bluetooth.

On your terminal again run.

$ sudo apt install solaar

After installation find Solaar on your menu programs open and run it or on the type Solaar.

Select the model of the receiver in this case mine is detected as M185n instead of M238 which can be found on the mouse label, it doesn’t matter though just select what is detected.

As we can see from the screen the menu for Scroll Wheel Diversion is enabled. Click the padlock icon and set the menu to off. (Scrool Wheel Diversion effectively disables the mouse scroll wheel function). Make sure to turn this off to enable mouse scrolling.

Once the setting is off the mouse scroll function will work immediately, and you have restored the mouse scrolling function on your Ubuntu Linux.

This might work on other Linux distributions just try it and leave some feedback if it works or not.

Ephraim Gariguez

Recent Posts

Zastone Radios Software

The following are software for radios by Zastone Technology this is publicly and freely available…

4 months ago

PHP 8.2 FPM Tuning

This is a personal note for myself to remember the process I used to tune…

4 months ago

Kicad 6.0 Fix or Workaround for OpenGL required version 1.5

Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…

2 years ago

2 Elements Yagi VHF antenna for 144Mhz

If you liked the 3 elements yagi, this antenna build is very close to the…

2 years ago

2 Elements Yagi UHF antenna for 410Mhz

This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…

2 years ago

WLN Softwares

WLN UHF Radio programming softwares and image for the following models below. The small radio…

2 years ago