A folded dipole is an antenna with the ends folded back forming a loop. The impedance of this antenna is around 300 Ω, so you may want to use a transformer or a λ/4 long piece of 120 Ω coaxial or 75 Ω cable to match this impedance to 50 Ω. Geometry is not that critical.
Note: This procedure is also tested to work with Pop!_OS 22.04 LTS I have an…
The following are software for radios by Zastone Technology this is publicly and freely available…
This is a personal note for myself to remember the process I used to tune…
Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…
If you liked the 3 elements yagi, this antenna build is very close to the…
This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…