Datasheet for RF Finals for QYT KT8900 Juentai JT-6188 aka MP300, 8900mini
VHF / UHF Compact Mobile Frequency Range 136-174 / 400-480 MHz
I have an M238 RF mouse that works perfectly fine on Windows and suddenly stop…
The following are software for radios by Zastone Technology this is publicly and freely available…
This is a personal note for myself to remember the process I used to tune…
Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…
If you liked the 3 elements yagi, this antenna build is very close to the…
This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…
View Comments
good day.. where we can buy kt980plus finals and kt8900d ?
please try ebay or ali express
Boa Noite! Algum colega teria disponivel o schematic do QYT KT7900D ou a Firmware para update desse equipamento? O meu radio ao energizar ligar dar o power ele ja entra em TX e apos o tempo de programa;'ao que deixei 15segundos ele automaticamente entra na tela normal mas porem fica inoperante nao transmite e nem recebe ou melhor sem TX e RX! Para eu conseguir ter RX vou na fun;ao MONI ai funciona!
Thanks for visiting but sorry Marcos, I don't have the schematic for your QYTKT7900D
Why are the replacement finals in your link only rated for 6w @ 7.5 volts?
if the radio is rated @ 25w @ 13.5 volts .. How then do they get 25w output ?
I do see finals rated @ 25w and 16w @ 13.5v. (NXP)
Thanks for all your great help and information.
Robert - N3BZ
It looks like that they overdrive the RF finals, it can support a 3dB overdrive @ 10.08vdd with no device degradation as referenced on the datasheet, however due to heat sink construction and placement on the PCB it cannot absorb the extra heat being generated by the device which causes premature burned RF finals on most QYT KT8900. If you have one you can check out the RF finals on your radio and you will see that it has the same RF finals with 6W output rating installed on it.
Thanks you for your reply !
Yes, I am seeing same .. and repairing units w/ correctly rated devices.
The 6/7/16w watt versions from ST/NXP in powerso-10 packages are inexpensive
per say (~$6 us) ... where the 25w device is much more expensive (~$29 us).
Does anyone know of a manufacturer which can provide 12v@25w which can
is less then the above price?
Thanks -
Robert - N3BZ
I'm not sure of any other manufacturer that can provide that, since I also imported that device from China through ali express, when mine blows up. It's not available here locally although NXP have a factory in Calamba, Philippines they are probably selling it to those companies that manufactures low cost radios in China exclusively.
Kt 8900 saya ga bisa transmit,walaupun finalnya sudah di ganti baru mohon penjelasan yang lainnya.terima kasih
Check the diagram if there are other issues with the radio, if radio finals is the problem your radio can at least transmit on very short distance if there are other issues for sure the RF signal is not going through the RF finals so there must be other fault in the radio's circuit.