Categories: Amateur Radio

Some hardware modifications for Baofeng’s UV5R/UV82

Here are some hardware modification to improve your Baofeng’s radio performance. These are not my own but an article found on the internet from DG2IAQ and KX3DX. If you’re into fixing and breaking things then this article is a must try. I have done some modification on my radio and I can say that the performance enhancement is worth the trouble. See the preamp modification using Vox transistor here.

Another modification lists from KX3DX for UV5R.

(adsbygoogle = window.adsbygoogle || []).push({});
(adsbygoogle = window.adsbygoogle || []).push({});
(adsbygoogle = window.adsbygoogle || []).push({});
Ephraim Gariguez

Recent Posts

Kicad 6.0 Fix or Workaround for OpenGL required version 1.5

Kicad 6.0 is an schematic entry and pcb layout editor software that is popularly used…

1 year ago

2 Elements Yagi VHF antenna for 144Mhz

If you liked the 3 elements yagi, this antenna build is very close to the…

1 year ago

2 Elements Yagi UHF antenna for 410Mhz

This 2 elements yagi antenna is intended for the 70cm UHF band center frequency is…

1 year ago

WLN Softwares

WLN UHF Radio programming softwares and image for the following models below. The small radio…

1 year ago

TYT Radios Softwares/Firmwares

Software Download Service for TYT Radios This page provides downloads for TYT Radios firmware and…

2 years ago

2m Vertical Dipole Array

Build a high gain 2meter vertical dipole array with this antenna plan. Ideal for repeater…

2 years ago